You are not logged in to Prodigits. Please register or login. You are not logged in to Prodigits. Please register or login.
Subject: Very old programmer
Replies: 5 Views: 913
dmpb 17.10.14 - 02:25pm
I need to program micro controller but only using wired programmer for basic write and read on chip so without software just only hand with wire for creating timing sequential ,any answer please ,thanks * +
mok214 18.10.14 - 02:01am
Basic, or would it be hexadecimal? Hexadecimal is usually what is used for writing firmware. * +
dmpb 18.10.14 - 03:52am
yes of course by using mnemonic from hexa decimal code but i dont sure it can be for success * +
dmpb 18.10.14 - 03:56am
I have been design basic digital programmer for programming micro controller ...it will be cmos or TTL for attempting hex code into micro controller or PIC * +
usbcable 30.10.14 - 04:51pm
You could try and buy a pickit2 or pickit3 programmer for not too much money. Wire it to the pins on a pic micro controller. Connect it to a computer with USB cable and write your code using mplab software on the computer then program the pic. * +
veronee 9.11.14 - 03:39pm
FTDI (voltage-ground TX0 TX1 ) USBASP also both are used to program Atmel tiny chips aka arduino PIC-MC, infact you can grb the maincode from the arduino forum and have TTL code to tinker with *
+ refresh
+ my page
+ functions
3 search
4 submit a reply
+ bookmark
8 Tech&Computers Forum
9 Forum Index
