You are not logged in to Prodigits. Please register or login.

Subject: rrod fix
Replies: 62 Views: 8545

g0l1ath1 8.01.09 - 07:03pm
im copying ans pasting this info from www.llamma.com any more info go to their site * +

g0l1ath1 8.01.09 - 07:03pm
We have found a combination of hardware we like best. We went with a longer screw than some recommend for ease of installation. We use 16 of the M5 x 1mm washers, 8 Nylon M5 x 1mm washers and 4 M5 Cheese head 12mm screws. * +

g0l1ath1 8.01.09 - 07:03pm
To install this you will need to disassemble your xbox 360 * +

g0l1ath1 8.01.09 - 07:04pm
Remove the DVD drive by loosening the tape in the front of the console, lift the DVD drive and detach the two cables from the motherboard at the rear. * +

g0l1ath1 8.01.09 - 07:04pm
Remove the fan shroud using a small slotted screw driver or any other small flat tool to push the tab holding it in place and lift up and out. * +

g0l1ath1 8.01.09 - 07:04pm
Next, unplug the fan. Then lift up on the steel flap holding the fan in place while pulling it toward you. * +

g0l1ath1 8.01.09 - 07:04pm
Remove the power b*tton / wireless controller board using your T8 driver. There are three screws; one is hiding behind the plastic LED lens cover * +

g0l1ath1 8.01.09 - 07:04pm
Remove the all 8 heat sink screws (T8) holding the processors to the chassis. * +

+ go to page 1-9
+ my page
+ functions
3 search
4 submit a reply
7 last page
+ bookmark
8 Games Forum
9 Forum Index

Custom Search